
Securing Cargo in a Container: What the CTU Code Requires and Who Pays for Damage
Sealed box, wrecked cargo
A machine builder in Ohio ships a 20-foot container of three hydraulic presses on wooden skids to Savannah for export to Rotterdam. The seal is intact on arrival. Inside, one press has tipped onto the crates beside it and another has slid into the side wall and bowed it outward. The carrier cites insufficient packing; the insurer cites the same exclusion. The $41,000 repair bill stays with the exporter, plus the container repair.
This is not unusual. Marine insurers consistently attribute a significant share of container cargo claims to poor packing rather than heavy weather, although no reliable global figure is published. The reference that defines good practice is the CTU Code.
The CTU Code and who it targets
The IMO/ILO/UNECE Code of Practice for Packing of Cargo Transport Units, known as the CTU Code, was adopted in 2014 (MSC.1/Circ.1497). It replaced the 1997 guidelines and covers containers, swap bodies, trailers and rail wagons. It is not a treaty, but it is the yardstick surveyors, underwriters and judges apply when deciding whether goods were fit for carriage.
Its key contribution is the chain of responsibility: consignor, packer, shipper, carrier and consignee. The party that loads and secures the goods is the packer, and securing is the packer's job. For a full container load that is never the ocean carrier, which receives a sealed box and knows its contents only from the declaration. Under US COGSA (46 U.S.C. 30701 note, § 4(2)(n)) and under the Hague-Visby Rules applied by the UK Carriage of Goods by Sea Act 1971, the carrier is not liable for loss caused by insufficient packing. India's Carriage of Goods by Sea Act 1925 contains the same defence.
The Code also covers container cleanliness, since soil, pests or residue can hold a shipment at destination, and accurate weight declaration, covered in our article on verified gross mass (VGM).
Design forces by mode
Cargo must withstand the accelerations it will meet, expressed as a fraction of its own weight (g). The Code sets them by mode and, at sea, by sea area, defined by significant wave height.
| Mode | Longitudinal | Transverse | Vertical (variation) |
|---|---|---|---|
| Road | 0.8 g forward, 0.5 g rearward | 0.5 g | — |
| Sea area A (waves ≤ 8 m) | 0.3 g | 0.5 g | ± 0.5 g |
| Sea area B (8–12 m) | 0.3 g | 0.7 g | ± 0.7 g |
| Sea area C (> 12 m) | 0.4 g | 0.8 g | ± 0.8 g |
Source: CTU Code 2014, chapter 5. US road values match the FMCSA performance criteria in 49 CFR 393.102. Rail has its own factors.
Two practical points follow. First, the truck leg often sets the hardest longitudinal requirement: a 0.8 g emergency stop exceeds anything the ship produces fore and aft, so a load poorly blocked forward often fails before it reaches the port. Second, transverse is the critical direction at sea. Rolling pushes cargo into the side walls, the weakest part of the box: ISO 1496-1 designs them for 0.6 times the payload spread evenly, and the end walls for 0.4 times. That works for cartons bearing across the whole wall, not for a machine striking one point. A transpacific or North Atlantic winter crossing typically falls in area B or C; the sea area chart is in the Code.
Blocking, lashing and void fill
Blocking braces cargo against the container structure, directly or through timber. It is the safest and cheapest method because it uses the strength of the walls and floor rather than the anchor points. A cleat nailed to the floor in front of a machine, or a crossbar wedged between corner posts, absorbs forces that straps could not.
Lashing restrains cargo with webbing, chain or wire tied to anchor points, and those points are weak. ISO 1496-1 typically requires 1,000 daN (about 2,250 lbf) for floor anchors and 500 daN (about 1,125 lbf) for roof and wall points. A 2-inch strap with a 3,335 lb working load limit hooked to a 2,250 lbf ring is a 2,250 lbf lashing. Heavy items need several anchor points or a dedicated frame.
Void fill keeps packages from gaining momentum. Airbags, empty pallets, panels or foam close the gaps; a foot of free space between pallet rows becomes an impact on every roll. Load distribution matters too: a common rule of thumb is that no half of the container length should carry more than about 60% of the cargo weight, and concentrated loads need timber bearers, because the floor is tested for a forklift axle of 7,260 kg, roughly 16,000 lb (ISO 1496-1), not for a coil sitting on two points.
Three worked examples
Figures below are working assumptions; friction values are indicative and the Code lists them by material pair.
Example 1 — the 8,800 lb press. A press weighing 8,800 lb sits on a wooden skid. Taking friction at a conservative 0.3, friction holds the equivalent of 0.3 g. In a simplified check that ignores the vertical component (the Code includes it, which raises the requirement), the forward road force left to restrain is 8,800 × (0.8 − 0.3) = 4,400 lbf; transversely in sea area C it is 8,800 × (0.8 − 0.3) = 4,400 lbf as well. Two floor anchors at 2,250 lbf each barely cover one direction with no margin. A timber block against the front wall, roughly $80–150 in material and labor (an estimate), handles the forward case outright.
Example 2 — the gap across the box. A Mumbai exporter loads 48 × 40 inch pallets of packaged spices into a 20-foot container (inside width about 92.6 in). One pallet lengthwise and one crosswise take 88 in, leaving 4.6 in per row, plus a gap at the door. Eight airbags at $10–20 each (an estimate), about $120 in total, close the voids. Without them, the typical result is crushed cartons on the outer rows, which surveyors commonly put at 5–10% of the load, or $1,750–3,500 on a $35,000 shipment.
Example 3 — the declined claim. Back to the Ohio presses: a $41,000 loss. The underwriter applies clause 4.3 of the Institute Cargo Clauses because the assured packed the box; the carrier pleads insufficient packing, and even if it were liable, COGSA would cap recovery at $500 per package, three skids here. Had a forwarder packed the container, the insurer would typically have paid and sought recovery from the forwarder. Coverage terms are compared in our guide to cargo transit insurance. A surveyor-approved securing plan, typically $350–700 (an estimate), would have cost under 2% of the loss.
Put stuffing and securing into your landed cost
Freight, insurance, duties and taxes: see what packing costs weigh in your delivered price.
Run the calculation →Making it routine
Four habits cover most shipments. Write into the sales contract who packs the container and to what standard; under EXW, a buyer who sends its own forwarder takes on the securing in practice. Choose the equipment to suit the cargo, not the reverse: tall or heavy machinery often travels better on a flat rack, as explained in our guide to choosing a container size. Inspect the box before loading, checking the floor, anchor points, watertightness and cleanliness. And photograph every stage of stuffing, door open and then closed with the seal number visible, because those pictures are often the only evidence left in a dispute.
Good securing costs tens to a few hundred dollars. Poor securing costs the cargo, because it is the one risk that neither the carrier nor the insurer will take on.
Frequently asked questions
Is the CTU Code legally mandatory?+
Not by itself. It is a code of practice adopted in 2014 by the IMO, the ILO and UNECE (MSC.1/Circ.1497). But surveyors, insurers and courts use it as the benchmark for whether cargo was properly packed, and many carriers reference it in their terms. In practice, ignoring it means carrying the damage risk alone.
Who is responsible for securing the cargo: the seller, the forwarder or the carrier?+
The Code assigns it to the packer, the party that loads and secures the goods in the unit. For a full container load that is almost always the shipper or its contractor, never the ocean carrier, which receives a sealed box. For LCL, the consolidator packs the container, but each shipper remains responsible for packaging its own pieces.
Are dunnage airbags enough on their own?+
They fill voids and stop cargo from building momentum, but they do not hold a heavy item against acceleration. They suit palletized cartons and bagged goods. Machinery, coils or heavy crates need timber blocking against the container structure or lashing to the anchor points, with airbags as a complement only.
Will cargo insurance pay for damage caused by poor securing?+
Usually not when the assured or its employees packed the container: clause 4.3 of the Institute Cargo Clauses excludes insufficient packing or preparation, and stowage inside the container counts as preparation. US open cargo policies typically carry a comparable exclusion. If a third party such as a forwarder packed it, the insurer generally pays and then pursues that party.
When is a lashing survey worth paying for?+
For standard palletized cartons, a written procedure and photographs are enough in most cases. For heavy, concentrated or irregular loads, a securing plan signed off by a marine surveyor, typically a few hundred dollars (an estimate), costs little against the claim it prevents and is the strongest evidence in a dispute.
Thomas Delaunay
Thomas focuses on landed-cost modeling and forwarder benchmarking. Previously a procurement lead at a mid-cap industrial importer, he builds the cost intelligence that powers TRADE-COST calculations.
Calculate your landed cost in 30 seconds
Duties, VAT, freight, insurance and margin — one form, one complete result.
Try the calculator →The TRADE-COST newsletter
Once a month: our analyses on customs, freight, and changes in international trade rules. No spam, one-click unsubscribe.
By subscribing, you agree to receive our emails. One-click unsubscribe from every email.
Related articles
Container fumigation and heat treatment: three obligations importers conflate
HT-stamped pallets do not satisfy a stink bug order, and a fumigated container without a gas-free certificate stays sealed on the dock. What ISPM 15 actually requires, why the EU accepts a treatment it bans at home, and how the bill lands on the consignee.
VGM explained: who weighs the container, and who pays when the terminal turns it away
Since July 2016, no packed container is loaded without a verified gross mass. The rule fits in one sentence; the failures do not. A shipper of record who never saw the cargo, a tare weight copied from a spec sheet, and a highway limit that binds long before the box rating are where the money goes.
Cross-Border Returns: What a Returned Parcel Really Costs
A return shipped back from London, Toronto or Dallas can cost more than the item is worth: return freight, duties already paid at the border, a fresh customs entry at home. Parcel-by-parcel returns, local returns hubs or refund-without-return — how to choose, and which duty refunds to claim on each leg.